Domino Clamps

An introduction to shipping container corner castings

An introduction to shipping container corner castings

What is a corner casting?

ISO1161 Corner castings are the big three-holed blocks of Corten steel which form the corners of all internationally standardised ISO shipping containers. They are the structural elements that are used to lift shipping containers as well as to connect them to whichever mode of transportation is being used to move the container such as ships, trains or road vehicles. They are also the connection point for shipping containers to be attached to each other, as in the case of stacks of containers aboard a container ship. 

In order that all lifting and container transportation equipment works properly across the world, these corner casting have holes in them which have been standardised to a tolerance of mere millimeters. It is because of this standardisation that Domino Clamps are guaranteed to fix to any ISO shipping container, anywhere in the world. 

Domino Clamps can be used in the shield or stadium holes on the corner casting

 

Where will I find them?

Corner castings are found on all eight corners of an ISO 6346 shipping container. They have three holes, one in each side of the outward facing surfaces of the casting. Sometimes, non standard containerised units will have been made using ISO1161 corner castings. Domino Clamps will of course work in these too but we advise that you exercise caution and take advice from the container manufacturer that the container itself can sustain the forces you plan to apply to the Domino Clamps. 

shipping container corner castings and where to find them


Are all the corner castings the same?

There are four ISO corner castings in total: top left, top right, bottom left and bottom right. The descriptions relate to the position of the castings as on the end and door faces of the container, as you look at the container from the outside. Each shipping container uses two of each of the four variations.

The most notable difference is between the top and bottom corner castings. While the bottom castings have two stadium shape holes on two sides (plus a large stacking hole underneath), the top castings have two differently shaped holes on the side, and the stocking hole on top. The top castings have a stadium hole on the long side of the container, and a shield hole on the front or rear end of the container. It is important to note that Domino Clamps fit both the shield AND and stadium holes, but NOT the much larger stacking holes on the top of the top casting and the underside of the bottom castings.

The left and right castings, both top and bottom are just mirror images of each other but are the same in all other respects.


A top left shipping container corner casting schematic drawing

 

How do I know if my shipping container is ISO standard?

If your shipping container is made to ISO standards it will have a code printed on the top right hand corner of the door as you look at it from the outside, it will also appear on the top right hand corner of the side of the container under the container number.


Do Domino Clamps work with other types of corner fitting?

There are various other types of corner fitting often found on containerised units, which to the untrained eye may look the same or similar to an ISO container. Be aware that if your container has any of these fittings in the image below, it is NOT an ISO container and Domino Clamps will not work in this type of fitting. Some look very similar in size and shape. Check the thickness of the steel at the stadium hole. If it is thin, anything less than about 18mm, then it is most likely not an ISO corner casting. 

Non ISO corner castings

To keep up to date with these How-To's, why not sign up to our information email and subscribe to our youtube channel (click to view and subscribe).

Leave a comment: